Reports
Our Top 5 Sellers
Performance of Edge Cutting and Sealing Methods
Price: £50
Ref: 98/WM/01/41
ISBN: 1 84057 143 8
Published: 1998
A review was made of the edge cutting and sealing methods currently in use for the reinstatement of vertical edges of highway openings. The Norton Clipper wet floor saw and the Stihl hand-held saw were shown to be more effective than the other cutting methods used. The TRL trial showed that the cold and spray applied edge sealing products were fast and easy to use and produced a good quality finish. The tensile and shear bond strength of the sealants were tested in a controlled laboratory environment. These tests indicated that the sealants fail in different ways so care must be taken when selecting a sealant for use.
Customers who bought this report also bought...
Deep Excavations: Compliance with the HAUC Specification and Long- Term Monitoring
96/WM/01/22 - ISBN: 1 84057 083 0Gives details on the practice, including the permanent surfacing, at five deep excavation sites. Reports on their compliance with HAUC specifications. Describes the long term monitoring of these and five additional new sites... More...
Price: £30
Add to basket
A Supervisor?s Guide for the Re- Use of Excavated Material
96/WM/01/21 - ISBN: 1 84057 110 1Gives an operational checklist of the re- use of excavated material. Specifies the HAUC classes of material (granular, cohesive and granular/ cohesive) and gives the HAUC field identification tests. Identifies and describes t... More...
Price: £30
Add to basket
A Code of Practice for Permanent Cold- Lay Surfacing Materials (PCSMs)
97/WM/01/31 - ISBN: 1 84057 017 2Produces an operational check list of procedures that a supervisor should follow. Describes the background to PCSMs, lists typical problems encountered and sets out the HAUC requirements. Finally details the material sampling... More...
Price: £30
Add to basket
Performance of Cold- Lay Surfacing Materials
97/WM/01/30 - ISBN: 1 84057 116 0Builds on earlier UKWIR work (97/WM/01/17) in assessing the quality and suitability of cold-lay surfacing materials. Gives results of tests on four material types for material strength, permanent deformation and void content.... More...
Price: £30
Add to basket
Deep Excavations: Compliance with the HAUC Specification
97/WM/01/32 - ISBN: 1 84057 018 0Gives details on the practice of deep excavations, including the permanent surfacing, at five sites. Reports on their compliance with HAUC specifications. Examines the relationship between compliance and actual performance. More...
Price: £30
Add to basket
Search all Books
© 